12V-72V LED Battery Capacity Indicator Battery Charge & Discharge Meter

12V-72V LED Battery Capacity Indicator Battery Charge & Discharge Meter

Remarks:

1. Please refer to the chart below before use to confirm that the voltage set by the DIP switch of the device is consistent with the current battery voltage. (The default voltage is set to 12V)

2. Make sure that the C terminal is connected to the battery positive terminal or the C terminal is connected to the battery positive terminal through the key switch. If the C terminal is not wired correctly, the device will not work properly. (LED indicator will not light up)

3. If the voltage of the DIP switch is set lower than the actual voltage of the battery, the device will not be damaged, and it can work normally if it is reset to the correct voltage value.

DIP switch definition table NO.2

DIP CODE DESCRIPTION: the switch is dialed to the top, which means "0" state, and the switch is dialed to the bottom, which means the "1" state.

Wiring Diagram NO.3

Functional description:

1. After power on, all LED lights will flash three times, indicating successful initialization.

2. After power on, if the LED light does not flash, it means the initialization failed, please power on again.

3. After the device is connected to the battery, the meter will automatically identify the current battery level.

4. When the device is powered on, the battery voltage is displayed, and the battery indicator is refreshed ev- ery 10 seconds

Specifications :

Product size: 

Operating Voltage: