OBDResource Universal U508 TPMS Relearn Tool

How to set Jeep vehicles into learning mode:

1. Inflate all tires to the pressure listed on the tire placard.
2. Turn ignition to ON position (engine off).
3. Press and release the MENU button on the overhead console until the message RETRAIN TIRE SENSOR - NO is displayed.
4. Press the STEP button to select YES.
5. Press the MENU button to start the relearn process.
6. Once the EVIC displays the message TRAINING COMPLETE, depress the STEP, C/T, RESET, or MENU buttons to exit the relearn procedure.

How to set GM vehicles into learning mode:

1. Make the gear in P position.
2. Use cruise to choose TPMS re-learn mode in the dashboard settings.
3. Horn will ring once and the TPMS indicator flashes, then learning mode has been entered successfully. If equipped, the message center will display the front left (LF) tire.

How to set Ford vehicles into learning mode:

1. Make the gear in P position.
2. Ignition switch to OFF, press and release the brake pedal.
3. Turn the ignition switch from OFF position to RUN position 3 times and end at RUN position.
4. Depress and release the brake pedal.
5. Ignition to OFF position.
6. Ignition goes from OFF position to RUN position 3 times and ends at RUN position.
7. Horn will ring once and TPMS indicator flashes, then learning mode has been entered successfully. If equipped, the message center will display the front left (LF) tire.

How to set Subaru vehicles into learning mode:

• Subaru series vehicles are different from the other vehicles, a properly formatted scan tool is required to enter TPMS learning mode before using the U508 tpms reset tool to learn new sensor IDs when replacing sensors.